<aside> ❔ For information about pairing pods, see Pair Pods

</aside>

Your Plantiga pods each contain a 6 axis IMU and sample at 416 HZ, weigh less than 20 g, and can collect up to 2 Gigabits of data.

Using your pods

• Charge your pods before collecting data. When the pods are docked and fully charged, the pod lights will turn green. The pods can collect up to 8 hours of data when fully charged.

• When the pods are docked and charging, the pod lights will be white. A full charge can take up to 2 hours.

• When the pods are docked and uploading data, the pod lights will blink white.

• If the pods are docked but not communicating, or there is an error the lights will rapidly blink red. Remove and replace the pods to ensure a good connection, or reconnect the dock to wifi via the setup app.

• When the pods are not docked, they will blink green when they have adequate remaining charge and blink red when there is an error or the battery is below 20%. The pods turn themselves off when the charge is below 5% to preserve collected data.

• Pods need to be synchronized daily to ensure that data timestamps are correct - make sure the pods are docked each day before use to allow them to synchronize.
• Dock the pods or keep them in the carry case or travel dock when not in use to prevent the battery from draining and the memory from filling up.

Managing your pods

• Pods currently paired to a person will be displayed next to their name in the People page.

  

  These pod chips will show the pod label and status.

  • 🔼 The triangle icon means the pod is undocked
  • 🔋 The battery icon means the pod is docked and charging. Mouse over the icon to see the charge percentage.
  • ✅ The checkmark means the pod is docked and fully charged.

• Pods currently pared to a person will also be displayed in their Profile under Pods.

  

• Navigate to Pods in the sidebar to see all the pods for your team.

  

  On this page you can see details for each pod, including the ID, the pairing status, the Pod and Dock firmware versions, and when the pod was last docked.

  Click EDIT to change the pod label (e.g. to a person’s name or your own numbering system).

  Pods can be deleted from this page if they have been lost or replaced.

• Click on the Dock icon next to the Pods page to show all pods that are currently docked, and who they are paired to.